Hand Held Power Tools
All power tools are designed for unique applications, they have their limitations and can create potential hazards when improperly used. Here are some points to remember when using power tools:
- The operation and repair of any power tool must be restricted to experienced, trained, authorized personnel.
- Select the proper tool for the job. The size of the power tool to be used is based on both the limitations of the tools themselves and the amount of work to be done.
- Always be alert to potential hazards in the area such as debris, damp floors or combustible materials. In wet areas, use insulated platforms, rubber mats, rubber gloves and rubber boots for an additional factor of safety.
- Make sure all power tools are of the double-insulated type or they are properly grounded. If the tool is equipped with a three-prong plug, use it as it is meant to be used. Electrical circuits intended for power tools should be provided with ground fault circuit interceptors (GFCI’s)
- Appropriate protective clothing should be worn at all times. Avoid wearing loose clothing or jewelry that can catch in moving-parts. Wear safety glasses, hearing protection, and / or a dust mask if the operation requires.
- Be sure not to handle a power tool in a manner that can injure you if it slips. Think about your movements and position your body accordingly. Keep proper footing and balance at all times. Avoid over reaching.
- Never rest a power tool against the body when loading or making adjustments. Use brushes, vacuuming equipment or special tools to remove chips or sawdust. Secure work using a clamp or vice when practical. Never apply a power tool to a moving object.
- Keep guards in place and in working order. Don't remove or wedge the guard out of the way. If the guard has to be retracted, use the handle on the guard.
- Beware of accidental start-up. Make sure the switch is OFF before plugging in the cord and before investigating a power loss. Do not carry a plugged-in tool with your finger on the switch.
- Have all power tools serviced by a professional if it shows the slightest defect or is not running properly.
- Clean your tools after you're finished with your work. Make sure keen-edged blades, drill bits, routers, etc. are sharp, regularly maintained and stored in a dry secure place where they won't be tampered with.
- Don't set the tool down or leave it unattended until all moving parts stop.